Installation Guide

Moorea Edge™ Shower Head

Guide ↓

 Installation

  1. Remove your old shower head
    Twist off your current shower head from the hose.

  2. Attach the Moorea Edge™
    Take your new Moorea Edge™ Shower Head.Twist it onto the same hose connection until it feels secure.

  3. Check the fit
    Turn on the water briefly to make sure there are no leaks.
    Tighten gently if needed.


 Replacement Filter

  1. Locate the filter section
    Just below the buttons, you’ll see a small twist-off compartment.

  2. Open the compartment
    Twist it off to expose the filter cartridge.

  3. Swap the cartridge
    Remove the used filter and discard it.
    Place a new filter cartridge inside.

  4. Close it up
    Twist the compartment back on until secure.

Pohnpei Fall™ Rain Shower

Guide ↓

Installation

  1. Remove your old rain shower head
    Twist off your existing rain shower head from the overhead pipe.

  2. Attach the Pohnpei Fall™
    Twist on your new Pohnpei Fall™ Rain Shower until snug.

  3. Test the connection
    Turn on the water to check for leaks.
    Tighten slightly if needed.


 Replacement Filter

  1. Find the filter compartment
    At the back of the Pohnpei Fall™, there’s a twist-off section.

  2. Open it up
    Keep the rain shower attached. No need to remove it from the wall.
    Twist off the back compartment to reveal the filter.

  3. Replace the cartridge
    Pull out the old filter.
    Insert the new cartridge.

  4. Close securely
    Twist the back compartment on until snug.

Pro Tips

  • Hand-tighten only. Tools can overtighten and damage threads.
  • If you notice reduced water pressure, it’s usually time to replace the filter.
  • Always use original replacement cartridges for best results.